FOCUSED WIDE BEAMS
This beam pattern is an excellent choice for multipurpose activities. At close range, focused wide beams simulate normal daylight conditions and allow you to take advantage of your peripheral vision.
HEATSINK TECHNOLOGY
Princeton Tec has developed proprietary ultralight heatsinks to protect LED products from overheating. Even though LEDs operate at much lower temperatures than traditional incandescent bulbs, they still generate heat. If this heat is not dissipated, the LED will suffer irreversible damage. By using heatsinks, Princeton Tec lights can burn at extreme brightness levels for long periods of time. The heatsink may be incorporated internally or externally depending on the product and its application.
LED OPTIC COLLIMATOR
A collimator gathers all available light from an LED in the form of scattered rays and re-emits the light as parallel rays, making it more optically efficient than a standard reflector. Princeton Tec calibrates each collimator to the type of LED and application of each light. With proprietary optimized collimator / lens systems, Princeton Tec continues to advance LED technology.
LUMEN 95
The light output of Princeton Tec lights is measured in lumens. A lumen
is unit derived by the International System of Units (SI) for measuring
light output.
MAXBRIGHT LED
The highest quality LED available from Lumileds, Princeton Tec’s Maxbright LED is extremely bright and efficient. This single LED emits a smooth, powerful, white light useful for a wide range of tasks. Princeton Tec uses collimators or reflectors with the Maxbright LED depending upon the application.
REGULATED LED / CONSTANT BRIGHTNESS
Princeton Tec lights that feature regulated LEDs have a sophisticated regulating circuit that maintains initial brightness as long as the batteries have sufficient voltage. Traditional lights are very bright initially, but immediately begin to dim and continue to dim until the batteries are drained. Constant Brightness is a term used to describe products that have regulated LEDs.
UL CERTIFICATION
Underwriters Laboratories Inc. (UL) is an independent, not-for-profit product-safety testing and certification organization. They have been testing products for public safety for more than a century. In order for a product to bear the certified UL Mark, it must pass all UL requirements at their testing facility. Princeton Tec lights that are UL certified fall into one of the following classifications: Class I – Division II – Groups A, B, C, & D or Class II - Division II – Groups F, & G. Refer to the comparison chart in the rear of the catalog. Class I – Division II – Groups A,B,C,& D will be noted with one (+) Class II – Division II – approved for Groups F, & G, will be noted with two (++).
WATERPROOF - LEVEL 3
The highest of Princeton Tec’s ratings, Level 3 is assigned to lights that offer a degree of water protection equivalent to IPX8 in the International Electrotechnical Commission (IEC) standards. Lights rated at Level 3 provide waterproof integrity for continual submersion in water at depths down to 100 meters.
Weight - 365
Princeton Tec’s advertised product weights always include batteries. For many products, battery weight is a large percentage of overall weight. Weight can be significantly reduced by using lithium batteries in lithium-compatible products.
